120018 - HPI SS-20WR SERVO (WATER-RESISTANT/6.0V/6.5KG/PLASTIC GEARED)
  • 120018 - HPI SS-20WR SERVO (WATER-RESISTANT/6.0V/6.5KG/PLASTIC GEARED)
  • 120018 - HPI SS-20WR SERVO (WATER-RESISTANT/6.0V/6.5KG/PLASTIC GEARED)

120018 - HPI SS-20WR SERVO (WATER-RESISTANT/6.0V/6.5KG/PLASTIC GEARED)

17,90 €
Su PVM
Turime vietoje
Atsiskaitymas visa paypal mastercard
message Klauskite apie šią prekę

Klauskite apie šią prekę

120018 - HPI SS-20WR SERVO (WATER-RESISTANT/6.0V/6.5KG/PLASTIC GEARED)

120018 - HPI SS-20WR SERVO (WATER-RESISTANT/6.0V/6.5KG/PLASTIC GEARED)

* Privalomi laukai

  Atšaukti

This water-resistant servo is ideal for bashers and racers looking for a tough and durable servo that can be used in wet conditions (e.g. rain, snow, puddles).

Features:

Operating Voltage: 4.8-6V

4.8V: Speed: 0.14 sec/60 degrees, Torque: 4.2kg-cm

6V: Speed: 0.11 sec/60 degrees, Torque: 6.5kg-cm

Servo Spline: 25T

Dimensions:

Main case: 40.7x39.4x20.0mm (excluding mounting tabs, servo spline, & cable outlet)

Mounting tab hole centres: 50.0x9.8mm

Weight: 42g (excluding servo horn)

NOTE: This servo is water-resistant only, meaning it is resistant to splashes and brief contact with water. It is not waterproof and therefore not suitable for submerged used. Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts. 

THIS PART FITS THE FOLLOWING KITS / PARTS:

Trophy Buggy 3.5

Trophy Truggy 4.6

Savage X 4.6

Bullet ST 3.0

Bullet MT 3.0

Bullet ST Flux

Bullet MT Flux

Micro RS4 1969 Ford Mustang RTR-X

Crawler King Ford F-150 SVT Raptor

SAVAGE XS FLUX VGJR

RS4 Sport 3 Drift 2015 Ford Mustang

JUMPSHOT MT V2.0

JUMPSHOT SC V2.0

JUMPSHOT ST V2.0

E10 TOURING MICHELE ABBATE

Savage XS Flux Chevrolet El Camino

RS4 SPORT 3 1987 WARSTEINER BMW

JUMPSHOT MT Flux

JUMPSHOT SC Flux

Jumpshot ST Flux

SAVAGE X 4.6 GT-6

WR8 3.0 2001 WRC Subaru Impreza

WR8 FLUX 2001 WRC Subaru Impreza

JUMPSHOT SC V2.0

JUMPSHOT SC Flux

RS4 SPORT 3 Creator Edition

120018
Komentarai (0)